IP54Digital Caliper, 0-6" Calipers Measuring Tool Electronic Micrometer Caliper

Description

IP54  Digital Caliper
1.This caliper is full stainless steel constructed, waterproof gaskets are plugged at the interface of the engine shell. It is of high protection from dust and water.
2.There are two display mode, Inch and Millimeter, which can be easily converted by one press on the mm/in button.
3.It has multiple measurement:it can accurate measure inner diameter,outer diameter, depth and step
4
..
Battery Change:There is a locked battery box on the main body. Facing down, thumb roller facing up. Using the small screwdriver provided, remove the screw on the same side as the thumb roller. After unscrewing the screw, the battery cover on the opposite side will be loose, and the battery can be easily changed
.
Technical Parameters
1.Product Name:IP54 Digital Caliper
2.Material:Stainless Steel
3.Display:LCD Screen display
4.Resolution:0.0005"/0.01mm
5.Accuracy:±0.001"/0.02mm
6.Repeatability:0005"/0.01mm
7.Battery:CR2035 Lithium Battery
8.Package:Plastic Box
Detail Shows
Measurement Way
1)
Measure the inside diameter of objects with the two short jaws. Put the two short jaws inside the subject, roll the thumb roller to against the subjects inner diameter
.
2)
Measure the outside diameter or length of an object with the two long jaws. By clamping the object between the two parallel sides of the long jaws and fixing it in place
.
3)
Measure the step with the two short jaws. Set the caliper vertically on the surface, roller the thumb roller until the upper short jaws’ lower section is parallel to the step
4)
Measure the depth of objects with the long probe on the end of the caliper. Put the probe into the objects inner part and roll the thumb roller to measure it’s depth
.