SL Match Grade Breech, Benjamin Marauder Gen2, Gen1 Cal .177, .22, .25*, .30*

Description

Side Lever Match Grade Breech for Benjamin Marauder for both Gen1 and Gen2 Mrods Cal .177, .22, .25*, .30*
Highest quality Match Grade Side Lever Breech for Benjamin Marauder for both Gen1 and Gen2 Mrods.
Premium quality Benjamin Marauder magazine included.
What's included:
1 - Super Match Grade Breech assembly.
2 - Premium quality Benjamin Marauder magazine.
3 - Air transfer port (polyamide tube, you must cut it for length needed)
4 - Longer Lever Axis screw to install on Gen1 Mrod.
5 -Special hammer upper screw to install on Gen1 Mrod.
6 -Barrel bushing with air transfer port installed to use barrel blanks without air transfer ports. But if you will install regular Mrod barrel, just put it away from the breech.
**
Technical Characteristics
Highest quality Dovetail Breech in .177, .22 or .25* Cal.;
Side lever gives you ability to use very high power hammer springs but with very comfortable cocking;
This breech is designed to use Benjamin Marauder magazines (Premium quality Benjamin Marauder magazine included);
An innovative way to lock the cocking lever. In the open position side Lever is held by a spring with the ball being in the back of the breech. In the closed position the lever is held by wedge + neodymium magnet which can be seen in the pictures.
Made from Materials
Breech material - Aircraft grade aluminum;
Breech covering - Black Anodizing;
Pellet pusher material - Brass;
**
Barrel bushing - Brass;
Tools Required
Screwdrivers;
Hex keys;
Silicone grease for O-rings;
Important to know
Marauder long screws for tube mounting not included!
**
Barrel Bushing with air transfer port already installed to use barrel blanks without air transfer port. You need to make pellet entrance (just make a little cone in barrel)
But if you will use regular Marauder barrel just put this Bushing away from the breech.
Also barrel hole in breech is 10.98mm but Standard Crosman barrels are 11mm and the diameter varies. So you must machine your barrel approx. 72mm length to 10.96mm diameter.
It's done so to make sure barrel always tightly sits in breech.
For .25 Cal there is 12.7mm barrel hole in the breech.
For .30 Cal there is 15mm barrel hole in the breech.
***
Due to our laws, all breeches are marked as .177 but are actually whichever caliber you ordered.
*
.25 and .30 Caliber breeches can only support our magazines that are included.
Note:
Please carefully read "Important to know" section before purchase.
These custom parts carry no warranty, and use may void factory warranty on the product to which they are installed. All sales on these parts are final.